亚洲色图10p,久久婷婷五月综合色欧美蜜芽,成人毛片无码一区二区三区,亚洲成av人在线视

High quality hydraulic equipment manufacturers!
TELL:+8613184968882

forklift cylinder Sold to Estonia

Release time:2023-11-12 15:32:04 Hits: Current position: Home > News

This article mainly introduces:

Estonia hydraulic cylinder,forklift cylinder manufacturer,forklift cylinder

Estonia forklift cylinder

(Estonia forklift cylinder,produced by Hengyu Group)

forklift cylinder are widely used in Estonia,because of no transmission clearance,long service life,smooth movement.So our company has designed forklift cylinder for customers from Estonia.

Introduction to forklift cylinder:

When the forklift cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

When the oil pressure of the forklift cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

When the forklift cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the forklift cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil forklift cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical forklift cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the forklift cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

The scar on the sliding surface of the forklift cylinder piston will transfer with use. Before the piston is installed, there are scars on its sliding surface, which are installed intact and untreated, and these scars will in turn scratch the inner surface of the forklift cylinder wall. Therefore, before installation, these scars must be fully repaired.

Answers to some questions about forklift cylinder:

How many kilograms can the 63 cylinder hold?
The force of the cylinder is related to the cylinder diameter and pressure. 63 cylinder diameter (cylinder inner circle diameter), 21MPA pressure, thrust 6 tons.

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP
日韩美女主播三级| 中文字幕一区高清在线播放| 操骚逼利视频| 五月婷视频在线观看| 亚洲色91精品三区二区一区| 美女视频网站白虎| 激情五月新地址| 中国美女干大逼| 曰本午夜福利神马一区二区| 用力插我逼射里面视频| 日本中文在线字幕免费观看| 高清无码六区| 欧美草逼大全套| 日本成年人视频一区二区| 啊啊啊…用力好爽AV| 激情五月 激情综合网| 亚洲一区激情在线视频| 亚洲日韩| 黑丝被草视频| 老司机超碰| 啪啪啪深夜福利| 美欧BBBB在线视频免费视频在线观看| 分宜县| 妇女逼视频www| 少妇一区二区视频吧| 久久精品破处视频| 啪啪日本免费| 娄烦县| 中午美女操逼视频| 逼逼内探视频| 日本不卡在| 日韩一区四区啊啊啊啊啊啊啊| 日屄的视频(免费)| 激情午夜av| 黑人大鸡巴操小骚逼| 91绝色熟女| 五十路熟妇无码视频| 美女小穴永久免费在线观看| 欧美日韩特级片视频播放| 日韩极品寂寞少妇在线播放| 日本不卡视频之中文字幕|