亚洲色图10p,久久婷婷五月综合色欧美蜜芽,成人毛片无码一区二区三区,亚洲成av人在线视

High quality hydraulic equipment manufacturers!
TELL:+8613184968882

500 ton hydraulic cylinder Sold to Uzbekistan

Release time:2023-11-08 15:23:24 Hits: Current position: Home > News

This article mainly introduces:

Uzbekistan hydraulic cylinder,500 ton hydraulic cylinder manufacturer,500 ton hydraulic cylinder

Uzbekistan 500 ton hydraulic cylinder

(Uzbekistan 500 ton hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd)

500 ton hydraulic cylinder are widely used in Uzbekistan,because of long service life,smooth movement,high work efficiency.So our company has designed 500 ton hydraulic cylinder for customers from Uzbekistan.

Introduction to 500 ton hydraulic cylinder:

500 ton hydraulic cylinders in series, parallel and series parallel. Series: In the 500 ton hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the 500 ton hydraulic cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the 500 ton hydraulic cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the 500 ton hydraulic cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

The piston seal of the 500 ton hydraulic cylinder is the main element to prevent leakage in the 500 ton hydraulic cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

When the initial action of the 500 ton hydraulic cylinder is slow, please check the temperature of the hydraulic system, because in the case of low temperature, the viscosity of the hydraulic oil is large and the fluidity is poor, resulting in slow action of the 500 ton hydraulic cylinder. The improvement method is to replace the hydraulic oil with good viscosity temperature performance, and the oil temperature at low temperature can be increased by heater or heating by the machine itself, and the normal working oil temperature of the system should be maintained at about 40 ° C.

The meaning of the 500 ton hydraulic cylinder model marked by the 500 ton hydraulic cylinder manufacturer: for example, 160/100-1150, its meaning: from a professional point of view, 160 refers to the 500 ton hydraulic cylinder diameter, which is 160mm, and the 100 behind refers to the rod diameter, which is 100mm. The 1150 refers to the 500 ton hydraulic cylinder stroke, which is 1150mm. Therefore, on this point, we should have a correct understanding and can not make mistakes.

Answers to some questions about 500 ton hydraulic cylinder:

How to distinguish the bucket cylinder from the bucket rod cylinder?
It can be distinguished according to its installation and connection: one end of the bucket cylinder is connected with the bucket; The rod cylinder is not connected to the bucket. The bucket refers to the bucket installed on the excavator. According to the working mode, it is divided into backhoe bucket and shovel bucket, the backhoe bucket is commonly used. The boom and bucket rod are working device of the excavator, usually called the big arm and the forearm, which are mainly used to control the digging and loading of the bucket. The arm connected to the frame is longer, so it is commonly known as the big arm, and its term is called the boom. The arms connected to the digging bucket are smaller, so they are commonly known as the lower arms, and the term is called the bucket rod, so they are commonly known as the big lower arms.

What is the material of the cylinder support ring?
Generally, it is polytetrafluoroethylene doped with copper powder, or polyformaldehyde, and copper sleeves, there are also nylon, resin and so on.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP
男女午夜久久久久| 好大久久久嗯啊视频| 熟女小穴麻豆| 美女被大鸡巴操逼好爽。| 欧美男男网大鸡巴搞孕妇| 被大鸡巴操穴国产毛毛| 丝袜精品人妻喷白浆一区| 深夜av成人| 老司机精品视频在线观看入口| 精品乱伦吸奶一区二区| 欧美大鸡巴久久久久久久| 岛国毛片:| 大鸡巴狂操欧美美女视频| 国产精品美女视频一区| www.男人天堂aV天堂| 天峨县| 香蕉亚洲视频| 色骚色麻豆| 日韩天美| 中文字幕一区二区三区四区五区六区日本 | 欧美人妻一区免费观看| 亚洲一线二线av在线| 老熟女36p| 操美女爽精品| 亚洲美女高潮喷水3p| 性生活视频加勒比在线| 日韩福利天堂| 亚洲AV好潮| 男女3p视频| 关于女生被插入内射的视频网站| 久女女热精品视频在线观看| 把校花操出白浆视频| 日韩久久精品秘av| 日本熟妇色wwwww日本| 18国产美女在线| 骚逼一区二区网| 抽插玩弄视频| 欧美被操视频| 啊…日我视频| 鸡巴艹艹艹| 国产黄片在线看,com|